www.actionmachinery.com
Action Machinery Co., Inc. Bethlehem Pa. Phone (610) 691-6677 Fax (610) 694-0944
Please Note: This page is displayed in a NEW Browser Window
Close this Window when you are done to return the Previous Page.
BRIDGEPORT SERIES II SPECIAL 3-AXIS CNC MILL WITH EZ-TRAK II CONTROL, 11" X 58"
DK-18131
S/N EZ2-BMI-1020
NEW 2002
SPECIFICATIONS
TABLE SIZE: 11" X 58"
TRAVEL
X-AXIS: 32"
Y-AXIS: 14.5"
Z-AXIS: 5"
KNEE: 12"
RAM: 17"
MAXIMUM LOAD DISTRIBUTED: 600 LBS
SPINDLE TAPER WITH POWER DRAWBAR: #30
SPINDLE SPEED RANGE: 60 – 4,200 RPM
SPINDLE DIAMETER: 1-7/8"
FLOOR AREA, DOORS CLOSED: 9' X 7'9"
HEIGHT: 6'9"
WEIGHT, WITH CONTROL: 3,900 LBS
ELECTRICS:
EQUIPPED WITH
3-AXIS EZ-TRAK II CONTROL
X, Y, & Z BALLSCREWS AND SERVO MOTORS
BOX CHROME WAYS
BIJUR AUTOMATIC LUBRICATION SYSTEM
BRIDGEPORT POWER DRAWBAR
COOLANT SYSTEM WITH GUARDING
MISCELLANEOUS TOOLHOLDERS
MANUAL OR CNC OPERATION
PRICE WILL ADVISE
REQUEST STOCK NUMBER
DK-18131
Get PreApproved Financing from Direct Capital Leasing !
Apply online
Download an Application Today !
Check your Payment with the DCC On-Line Leasing Calculator
Compound Interest Calculator
DISCLAIMER: The information presented in this write up and the Photographic representation of this equipment is believed
to be accurate at the time of this writing.
This by no means should be used for formal quotation. Price and Information presented in this write-up are subject to change without notice.
Please contact one of our sales representatives if you require more
information or a formal quotation.
Request information on DK-18131 via E-mail
Send a link to this page to someone via E-mail
www.actionmachinery.com
Action Machinery Co., Inc. Bethlehem Pa. Phone (610) 691-6677 Fax (610) 694-0944
This Web Site, all text and images contained herein are owned by and are copyright © 1996 - 2009 Action Machinery Co., Inc.
None of the contents of this site may be reproduced or republished with out written permission from Action Machinery Co., Inc.
This Site Developed and Maintained by:
George H. Patterson
I welcome any and all Comments and Suggestions
This Page was Created 11-12-2009 at 10:26:16